BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b340.fm 3-81
Operation
Grading and scraping
☞ Grading
• Fold up the front half of the bucket
• Set the depth of the layer you want to remove with the lift hydraulics
• Set the angle of the rear cutting edge
☞ Drawing material backwards
• Dump out the multipurpose bucket
• Raise the bucket with the lift hydraulics
• Fold up the front half of the bucket
• Lower the multipurpose bucket to the ground
• Set the angle of the bucket
• Surfaces are graded or scraped when driving in reverse
Removing and spreading material in thin layers
☞ Removing material in thin layers
• Set a flat digging angle
• Fold up the front half of the bucket by about 10 to 15 cm
• Move off the machine
➥ The material rolls into the bucket and is picked up at the same time
➥ This position allows to strip e.g. grass turf down to a thickness of about 8 cm
☞ Spreading material in thin layers
• Set the rear cutting edge parallel to the ground
• Fold up the front half of the bucket until the required quantity of material is emptied
onto the ground
• Move off the machine
• Lower the multipurpose bucket to the ground
➥ The rear cutting edge grades the material as it is emptied by opening the front half of
the bucket. This position allows to spread material without driving on the lower layer
with the machine (e.g. applying the first bituminous base onto sensitive antifrost
layers, applying granulated material onto plastic coatings)
Ansi cht_009.i so
Ansi cht_008.i so
Fig. 129: Grading work with a multipurpose bucket
Ansicht_007.iso
Fig. 130: Removing material in thin layers with a multipur-
pose bucket
To Next Page
Loading...
