Kramer 380

BA 35101/02/ 03 EN – Edition 1.0 * 35201_02b540.fm 5-47
Maintenance
Maintenance
5.24 Maintenance plan
Work description
For service and maintenance work on the attachment, please refer to the operation and maintenance manual of the
attachment manufacturer as well.
Work-
shop
Operator/driver Workshop
Delivery
inspection
Maintenance work
(once a day)
“A”
every 20 s/h
“A”
every 50 s/h
1st Inspection
1
at 100 s/h
“B”
every 500 s/h
2
2nd Inspection
“C”
every 1500 s/h
once a year
Oil and filter changes, fan bearing ( ):
Carry out the following oil and filter changes (check oil levels after test run):
• Engine oil
●● ●
• Engine oil filter
●● ●
• Fuel filter, fuel prefilter
●● ●
• Air filter insert
3,4
replace safety cartridge every 3rd time the air filter insert is replaced ●●
• Gearbox oil in front and rear axle differentials and in rear axle gearbox
●●
• Gearbox oil in front and rear axle planetary drives (left and right)
●●
• Hydraulic oil
5
●
• Microfilter (line filter in drive)
●●
• Hydraulic oil filter insert
●●
• Hydraulic oil tank breather filter
4
●
• Heating: fine-dust filter
6
●●
• Replace the fan bearing (Visco clutch)
Every 2500 service hours
Inspection work ( ):
Check the following material. Refill if necessary:
• Engine oil
● ● ● ●
• Hydraulic oil
● ● ● ●● ● ●
• Engine coolant
7
(also check antifreeze in autumn/winter and at temperatures below 4 °C!)
● ● ●● ●
• Gearbox oil in front and rear axle differentials and in rear axle gearbox
● ●● ●
• Gearbox oil in front and rear axle planetary drives (left and right)
● ●● ●
•Brake fluid
8
● ● ● ●● ● ●
• Check radiator for engine and hydraulic oil for contamination. Clean if necessary
9
● ● ●● ● ●