BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b330.fm 3-23
Operation
Putting the drive interlock back into operation again
☞ Press the (*) key for 2 seconds (ignition key in position OFF) until two short acoustic
signals are given for confirmation
➥ The system is enabled again. The code must be entered to start the engine.
Interruption of drive interlock power
If the drive interlock was enabled before electric power was interrupted, short acoustic sig-
nals are given upon switching on the keypad (similar to those that are given when entering
the wrong code four times). In this case, wait until the acoustic signals are no longer given.
Then disable the drive interlock with the personal or main code.
The LED still does not come on if the drive interlock was disabled. The engine can be
started before the LED starts flashing again.
If the drive interlock was out of operation, this status remains unchanged and the LED
flashes slowly.
Drive interlock maintenance
The drive interlock does not require any maintenance.
Protect the keypad and the control unit from heat and humidity
To Next Page
Loading...
