3-94 BA 35101/02/03 EN – Edition 1.0 * 35101_02_03b340.fm
Operation
3.61 Working with the automatic bucket repositioning (option)
General information on automatic bucket repositioning
The bucket repositioning function can be used for carrying out cyclical work (e.g. loading
trucks) efficiently and with minimum impact to the material: by pressing a button, the
attachment is automatically positioned from the dump-out position to the preset work posi-
tion (e.g. horizontal bucket base). However, the efficiency of the bucket repositioning is
ensured only if the attachment and the position of sensor a on the tilt ram are adjusted to
each other. This adjustment is carried out easily by means of the marks on bracket b for
the buckets listed in the table.
☞ Adjust the tilt ram sensor as follows:
• Pick up and lock the attachment in the quickhitch
–seeLocking and unlocking an attachment from the quickhitch on page 3-63
• Set the bucket to the base position (e.g. bucket base aligned horizontally with the
ground)
• Slacken the wing nut on sensor a (sensor bracket on tilt ram)
• Slide the sensor to the respective mark (notch) on bracket b and tighten the wing nut
☞ Enabling the automatic bucket repositioning
• Press tip switch 106 on the control lever
➥The attachment is automatically tilted in to the position that has been set
• Lower the loader unit to load position
☞ Disabling the automatic bucket repositioning
• Press control lever B to the right (dump out)
Fig. 148: Automatic bucket repositioning components
a
b
a
A
C
B
B
106
Notch Attachments
A Side swing bucket
B
Normal material standard bucket
Lightweight material standard bucket
Multipurpose bucket
C Pallet forks
To Next Page
Loading...
