BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b340.fm 3-77
Operation
Removing the multipurpose bucket from the quickhitch
In order to prevent the attachment from tipping over, place it on the ground
ensuring stability!
☞ Position the attachment so that after unlocking it will stand safely and not tip
over
The attachment is removed from the quickhitch in the same way as the stand-
ard bucket –seeRemoving a standard bucket from the quickhitch on
page 3-67
☞ Remove the multipurpose bucket as follows:
• Empty the multipurpose bucket and set it horizontally with the ground
• Stop the engine, but do not switch off ignition
• Apply the parking brake
• Release the pressure in the hydraulic lines of the 3rd control circuit
➥ –seePressure relief on the quickhitch couplers on page 3-65
• Remove flexible lines A and B from the quick couplers of the multipurpose bucket
and insert them into the quick couplers of the quickhitch
➥ Flexible line A onto quick coupler F
➥ Flexible line B onto quick coupler E
• Close the quick couplers on the multipurpose bucket with protective caps
• Start the engine and lower the multipurpose bucket to the ground
Never connect the hydraulic lines crosswise, otherwise the attachment
functions are inverted and the hydraulic lines squeezed by dumping the
attachment in and out.
☞ Check the multipurpose bucket for correct function
Fig. 127: Connecting the hydraulic lines onto a quickhitch
AB
E F
To Next Page
Loading...
