BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b340.fm 3-87
Operation
• When driving or working across a slope, the load must be on the uphill side of the
machine/attachment. Drive the machine backwards on sloping terrain to prevent the
load from falling off and the machine from tilting forwards when braking
• When transporting large bulk loads drive the machine backwards for improved visibility
• Observe the load-bearing capacity of bridges, basement ceilings, vaults etc., before
moving the machine on them!
• Bear in mind the clearances of underpasses, tunnels, gates etc. before driving through
or under them!
• Do not overload the attachment or the machine, observe the load diagram!
• Set down loads only in places where they will stand safely without tilting, falling down or
sliding
• Observe the load-bearing capacity of the set-down area (e.g. truck platforms, storage
area in high-bay warehouses etc.)
• Load the loading area of vehicles or trailers evenly and distribute the load evenly on the
axles
• Stack loads only up to the authorised maximum pallet height
• Do not set down loads too near to slopes, construction pits etc.
• Set down loads only in the areas provided for within the construction site. Affix appro-
priate marks to loads which have been set down, especially in the area of public and
private traffic
• Do not set down loads in transit or escape routes, and not in front of safety facilities or
works equipment which must be accessible at any time
To Next Page
Loading...
