Kyocera Printserver - 4.3 Saving the IP Address in the Print Server

Saving the IP Address in the Print Server
4-6 Print Server Installation Manual
4.3 Saving the IP Address in the Print Server
There are several methods available for saving the IP address in
the print server.
Please read the "Methods of Saving the IP Address in the Print
Server" section on page 1-7 if necessary.
Select one of the following methods:
Saving the IP Address via BOOTP
Saving the IP Address via RARP
Saving the IP Address Using the 'arp' and 'ping' Commands
KYOCERA Printer Operating Panel
PRESCRIBE Commands for KYOCERA Printers
4.3.1. Saving the IP Address via BOOTP
If the BOOTP boot protocol has been installed in your network,
you must edit the '/etc/bootptab' file. The procedure is somewhat
different for ULTRIX systems. If you use an ULTRIX system,
please read the "Procedure for ULTRIX" section on page 4-7.
Please note that (optional) periods separate the address groups of
the hardware addresses in this file, whereas colons separate fields
from each other in an individual entry. In ULTRIX and some other
UNIX systems, the individual fields of an entry are separated from
each other using the tab character.