Kyocera Printserver - Setting up the Printer

Installing in Windows Networks (peer to peer printing via NetBIOS)
Print Server Installation Manual 3-5
or the parameter transfer via FTP. The configuration using the print
server homepage is described below.
The print server can only be set up in an existing workgroup or
domain. If necessary, set up new workgroups or domains in
advance.
Procedure Proceed as follows:
1. Call the 'Configuration - Microsoft Windows' page from the
print server hompage.
2. Select 'NetBIOS' if necessary.
3. Enter an existing workgroup or domain in the 'NetBIOS
domain' box.
4. Click 'Save.'
The print server can now be seen in the corresponding
workgroup or domain.
3.2.4. Setting up the printer
Finally, the printer must be set up.
Procedure Proceed as follows:
1. Click on the print server in the corresponding workgroup or
domain.
2. In Windows 98 and 95 networks double-click the desired
logical printer. In Windows NT networks do a right click on
the desired logical printer.
3. Follow the instructions of the installation routine.