Kyocera Printserver - Starting PSERVER on the File Server

Installing in Novell NetWare 3.x Networks in Remote Printer Mode
2-52 Print Server Installation Manual
6. Select a logical printer from the 'Logical printer' box if
necessary.
7. Click 'OK' to confirm.
2.6.6. Starting PSERVER on the File Server
In the last step, the Novell print server must still be installed into
the PSERVER module of the file server so that the print data can
be sent from PSERVER to the KYOCERA-PrintServer. To this
end, the PSERVER module with the PSERVER name entered in
PCONSOLE must be started.
Procedure Proceed as follows:
1. Start PSERVER on the file server with the PSERVER name
entered using PCONSOLE.
Syntax: LOAD PSERVER <PSERVER name>
Example: LOAD PSERVER MY_PRINT_SERVER