Kyocera Printserver - 4.5 Printing via TCP;IP Ports

Printing via TCP/IP Ports
Print Server Installation Manual 4-23
4.5 Printing via TCP/IP Ports
If the LPD protocol is not available, such as in SINIX SPOOL
networks, you can use direct TCP/IP ports for printing. If this is
the case, you must configure the port number. To enable this
function, install a printer port and enter the port number.
Please read the "TCP/IP Ports" section on page 1-15 if necessary.
4.5.1. SINIX SPOOL V4.x/XPrint
When installing the print server in SINIX SPOOL V4.x or XPrint
systems, you must install a server, a supervisor, and a printer.
Requirements Before installation, make sure that:
! The IP address has been saved in the print server.
! The host name has been assigned to the IP address.
! The print server is connected, and the printer is turned on.
Procedure Proceed as follows:
1. Install a new server into the spooler:
Syntax: xpadd -srv <server name> -sp <time control>
Example: xpadd -srv server1 -sp PRIORITY
2. Install a new supervisor into the spooler:
Syntax: xpadd -spv <supervisor> -se <server name>
Example: xpadd -spv admin -se server1