Kyocera Printserver - Creating an Output Queue

Creating an Output Queue
Print Server Installation Manual 6-11
6.3.2. Creating an Output Queue
An output queue may be created using the CRTOUTQ command.
Depending on the AS/400 system, the handling may slightly differ
from the following description.
Procedure Proceed as follows:
1. Enter the CRTOUTQ command at the system console.
The following window appears:
Fig. 6-7: 'Create Output Queue' window
2. Press F9 and F10 to display all configuration parameters.
3. To display the keywords, press F11.
4. Enter the following parameters into the mask:
OUTQ <arbitrary name> e.g. MY_QUEUE
RMTSYS <IP address of the print server>
e.g. 192.168.0.123
5. Press the page down key to change to the next screen.