Kyocera Printserver - Setting up the Printer on the Computer

Installing in NetWare 5/4 Networks in Remote Printer Mode
2-18 Print Server Installation Manual
data from PSERVER to the KYOCERA-PrintServer. This requires
the starting up of the module PSERVER with the name of the
PSERVER entered in the KyoNetCon.
Procedure Proceed as follows:
1. Start the PSERVER on the file server with the PSERVER
name which you entered in the KyoNetCon.
Syntax: LOAD PSERVER <PSERVER Name>
Example: LOAD PSERVER MY_PRINT_SERVER
2.3.4. Setting Up the Printer on the Computer
Now the printer has to be set up on each computer or workstation
that is to be used for printing. The following paragraph describes
the setup of the printer in Windows 98.
If necessary, please see the Windows Manual for instructions on
how to set up printers.
Procedure Proceed as follows:
1. Begin the printer installation.
The following window will appear during the installation
routine: