Kyocera Printserver - HP-UX (Version 10.20)

Printing via the LPD Protocol
4-16 Print Server Installation Manual
! The IP address has been saved in the print server.
! The host name has been assigned to the IP address.
! The print server is connected, and the printer has been turned
on.
Procedure Proceed as follows:
1. Stop the print daemon:
enq -G
2. Enter the print server into the '/etc/qconfig' file:
Syntax: <name of print queue>:
host = <host name of print server>
rq = <logical printer>
device = drp0
drp0: backend = /usr/lpd/rembak
Example: MY_QUEUE:
host = SB0001FF
rq = lp1
device = drp0
drp0: backend = /usr/lpd/rembak
3. Start the print daemon:
enq -U -P MY_QUEUE
4.4.4. HP-UX (Version 10.20)
The print server is installed in an HP-UX UNIX system as a
remote printer using either the System Administration Manager
(SAM) or directly using the Common Desktop Environment
(CDE) or, in older versions, the Visual User Environment (HP
VUE). Both methods differ from each other.
Requirements Before installation, make sure that: