Kyocera Printserver - Integrating Shell Scripts into System V Systems

Printing via Shell Scripts
Print Server Installation Manual 4-27
4.6.2. Integrating Shell Scripts into System V Systems
If the shell scripts are located in the '/etc/printserver' directory, you
must adapt them and integrate them into the spooler.
Installation Entries The installation sequence requires the following entries:
All three names may be assigned arbitrarily. You may also use one
name for all three entries. Every name assigned, however, must be
used continuously throughout the installation sequence.
Procedure The installation involves the following steps:
Adapting the Shell Scripts
Creating the Printer Device
Entering the Printer into the Spooler System
Enabling the Printer
4.6.2.1. Adapting the Shell Scripts
The shell script must be adapted to your network. A copy of the
shell script is therefore created and saved in the
'/etc/printserver/interfaces' directory. After that, the shell script is
adapted to your system. This basically means that the host name of
User input
Example in the
text
Name of the adapted shell script my_script
Name of the zero device my_device
Name of the printer (visible to the user after installation) my_printer