Installing in Windows 98 and 95 Networks (KYOCERA Monitor)
3-12 Print Server Installation Manual
What Is the
KYOCERA
Monitor?
The KYOCERA Monitor constitutes the connecting piece between
the computer and the print server in Windows 98 and 95 networks.
It enables the transfer of print data from the computer to the print
server via direct TCP/IP ports. The KYOCERA Monitor must be
installed and configured on every computer intended for printing.
It is not possible to share the printer.
Do not mix up the KYOCERA Monitor and the KYOCERA Print
Monitor, a tool to administrate printers in networks.
Procedure The installation involves the following steps:
Installing the TCP/IP Protocol
Saving the IP Address in the Print Server
Setting Up the Printer
Installing the KYOCERA Monitor
Setting Up the KYOCERA Monitor
3.4.1. Installing the TCP/IP Protocol
In order to be able to use your print server in a Windows 98 or 95
network, you must first install the TCP/IP protocol on the
computer intended for printing. If TCP/IP is already installed, you
may skip to the "Saving the IP Address in the Print Server" section
on page 3-15.
Procedure Proceed as follows:
1. Select 'Control Panel' on the 'Start' menu.
To Next Page
Loading...