Kyocera Printserver - Sunos; SCO UNIX (Version 3.2)

Printing via the LPD Protocol
Print Server Installation Manual 4-19
4.4.5. SunOS
When installing the print server in SunOS systems, you must enter
the print server into the '/etc/printcap' file.
Requirements Before installation, make sure that:
! The IP address has been saved in the print server.
! The host name has been assigned to the IP address.
! The print server is connected, and the printer is turned on.
Procedure Proceed as follows:
1. Add the following entry to the '/etc/printcap' file:
Syntax: <printer name>:\
:lp=:rm=<host name>:rp<logical printer>:
Example: my_printer:\
:lp=:rm=SB0001FF:rp=lp1:
2. Enable the printer:
Syntax: lpc
lpc> enable <printer name>
lpc> start <printer name>
lpc> quit
Example: lpc
lpc> enable my_printer
lpc> start my_printer
lpc> quit
4.4.6. SCO UNIX (Version 3.2)
In SCO 3.2 systems, remote line printing (RLP) is used. When
installing the print server, you must first install RLP into the SCO
server and then install the print server as a remote printer.