Saving the IP Address in the Print Server
4-10 Print Server Installation Manual
4.3.5. PRESCRIBE Commands for KYOCERA Printers
You can use PRESCRIBE commands to save the IP address in the
print server.
In addition to the IP address, you can also change other parameters
using PRESCRIBE commands. Please read the "Configuring
Parameters Using PRESCRIBE Commands for KYOCERA
Printers" section on page B-18 of the User Manual if necessary.
Procedure Proceed as follows:
1. Create an ASCII file and assign it an arbitrary name.
2. Insert the following entry into the file:
Syntax: !R!SIOP2,"IP:<IP address>";EXIT;
Example: !R!SIOP2,"IP:192.168.0.123";EXIT;
3. Transfer the file to the print server as a print file via the
parallel, serial, or KUIO interface.
PRESCRIBE commands cannot be used if a password has been
assigned to the print server.
To Next Page
Loading...