Kyocera Printserver - IBM AIX (Version 3.X)

Printing via the LPD Protocol
Print Server Installation Manual 4-13
*BACKEND PROGRAM pathname [/usr/lpd/rembak]
ACTIVATE the queue? yes
Should this become the Default queue? no
Queuing DISCIPLINE first come first serve
ACCOUNTING FILE pathname [ ]
HOSTNAME of remote server [SB0001FF]
Name of QUEUE of remote server [lp1]
5. Press ENTER to confirm.
6. Check whether the following entry has been added to the
'/etc/qconfig' file:
Example: MY_QUEUE:
device=MY_QUEUE
up=true
host=SB0001FF
rq=lp1
MY_QUEUE:
backend=usr/lpd/rembak
7. Change to the 'etc' directory.
8. Test the print server:
Syntax: lp -d <host name of print server> <file name>
Example: lp -d SB0001FF hosts
4.4.2. IBM AIX (Version 3.x)
When installing the print server into the spooler of an AIX system
as a remote printer, you must enter a print queue, a host name, and
a logical printer into the '/etc/qconfig' file. In this section,
installation by means of the SMIT Administration Tool is
described.