Printing via the LPD Protocol
4-12 Print Server Installation Manual
a logical printer into the '/etc/qconfig' file. In this section,
installation by means of the SMIT Administration Tool is
described.
Installation Entries The installation sequence requires the following entries:
Requirements Before installation, make sure that:
! The IP address has been saved in the print server.
! The host name has been assigned to the IP address.
! The print server is connected, and the printer is turned on.
Procedure Proceed as follows:
1. Log on as root.
2. Start SMIT.
3. Select the following menu commands in the order shown
below:
'Devices'
'Printer/Plotter'
'Print Spooling'
'Add a Print Queue'
'Other'
4. Enter the following parameters into the screen mask:
[TOP]
*Name of QUEUE to add [MY_QUEUE]
*Name of QUEUE DEVICE to add [MY_QUEUE]
Box in SMIT User input
Example
in text
Name of QUEUE to
add
<arbitrary name> of print queue MY_QUEUE
HOSTNAME of
remote server
<host name or IP address> of print server SB0001FF
Name of QUEUE of
remote server
lp1 to lp8 for the logical printer lp1
To Next Page
Loading...