Basic TCP/IP Terminology
Print Server Installation Manual 1-13
1.2.2.6. PRESCRIBE Commands for KYOCERA Printers
You can also use PRESCRIBE commands to save the IP address
in the print server.
In addition to the IP address, you can also change other parameters
using PRESCRIBE commands. Please read the "Configuring
Parameters Using PRESCRIBE Commands for KYOCERA
Printers" section on page B-18 of the User Manual.
Procedure Proceed as follows:
1. Create an ASCII file and assign it an arbitrary name.
2. Insert the following entry:
Syntax: !R!SIOP2,"IP:<IP address>";EXIT;
Example: !R!SIOP2,"IP:192.168.0.123";EXIT;
Transfer the file as a print file to the print server by means of the
parallel, serial, or KUIO interface.
PRESCRIBE commands cannot be used if a password has been
assigned to the print server.
1.2.3. Host Name
What Is the Host
Name?
The host name is an alias for an IP address. We recommend that
you always use a host name. If the IP address changes, only the
file containing the allocation of the host name to the IP address
must be changed. The host name used to address the print sever in
your local network may be chosen freely. The chosen name should
To Next Page
Loading...