Basic TCP/IP Terminology
1-8 Print Server Installation Manual
The following possibilities for saving the IP address are available:
DHCP
The BOOTP Boot Protocol
The RARP Boot Protocol
The 'arp' and 'ping' Commands
KyoNetCon
KYOCERA Printer Operating Panel
PRESCRIBE Commands for KYOCERA Printers
1.2.2.1. The BOOTP Boot Protocol
If your network uses the boot protocol BOOTP, the '/etc/bootptab'
file must be supplemented. This file is located on the host running
the BOOTP daemon. The '/etc/bootptab' file contains a permanent
copy of the allocation of the host name and the IP address to the
hardware address.
Requirements Make sure that:
! The 'BOOTP' parameter has been activated (see status page).
What Happens
When the Print
Server Is Turned
On?
Once the print server has been turned on, it asks the BOOTP for
the IP address and the host name. The answer of the BOOTP host
server, which contains the IP address, is sent as a data packet and
saved in the print server.
What Happens
When Printing?
During the installation of the print server, its host name is
displayed on the monitor of the computer intended for printing.
The computer finds the IP address of the print server by means of
To Next Page
Loading...