Leader LT4670 - Recalling Presets; Storing Presets

14 SYSTEM CONFIG MENU
135
14.2.1 Recalling Presets
To recall a preset that has been stored with the STORE menu, follow the procedure below.
Procedure
SYSTEM CONFIG > PRESET > RECALL
To recall a preset, follow the procedure below.
1. Select a preset number.
Select a number from NUMBER 0 to NUMBER 9.
If a comment was added on the COMMENT INPUT menu, the comment is also displayed.
With no comment
With a comment
2. Select OK.
14.2.2 Storing Presets
You can save up to 10 presets by following the procedure below.
Procedure
SYSTEM CONFIG > PRESET > STORE
To store a preset, follow the procedure below.
1. Select a preset number.
Select a number from NUMBER 0 to NUMBER 9.
2. Select OK.
If the preset is already stored, an overwrite confirmation message is displayed.
To overwrite it, select OK. Otherwise, select CANCEL.
2 . R E C A L L
} N U M B E R 0
2 . R E C A L L N U M B E R 0
} N A M E [ R E F = B B , T I M E = G N S S ]
3 . R E C A L L N U M B E R 0
■ O K □ C A N C E L
2 . S T O R E
} N U M B E R 0
3 . S T O R E N U M B E R 0
■ O K □ C A N C E L
3 . N U M B E R 0 O V E R W R I T E ？
■ O K □ C A N C E L