Leader LT4670 - Adding a Comment; Power-On Settings

14 SYSTEM CONFIG MENU
136
14.2.3 Adding a Comment
To add a comment to a preset stored with the STORE menu, follow the procedure below.
The comment added here can be displayed when you recall the preset with the RECALL menu
or when you copy it from the instrument to a USB memory device.
Procedure
SYSTEM CONFIG > PRESET > POWER ON RECALL
Parameters
◀０１２３４５６７８９ＡＢＣＤＥＦＧＨＩＪＫＬＭＮＯＰＱＲＳＴＵＶＷＸＹＺ
ａｂｃｄｅｆｇｈｉｊｋｌｍｎｏｐｑｒｓｔｕｖｗｘｙｚ！＃＄％＆’（）＋，－．；＝＠［］＾＿｛｝
Initial value
◀
To enter a comment, follow the procedure below.
1. Select a preset number.
Select a number from NUMBER 0 to NUMBER 9.
2. Enter a comment.
You can enter up to 17 characters.
Enter ◀ to clear the characters that follow it. In this case, ◀ is not included in the
comment. Enter only ◀ to erase the comment.
14.2.4 Power-on Settings
To select the settings to use for starting the instrument, follow the procedure below.
Procedure
SYSTEM CONFIG > PRESET > POWER ON RECALL
Parameters
OFF: The instrument starts with the same settings that were set when
it was last turned OFF.
NUMBER 0 to NUMBER 9: The instrument starts with the selected preset.
Initial value
OFF
2 . C O M M E N T I N P U T
} N U M B E R 0
3 . C O M M E N T I N P U T N U M B E R 0
R E F = B B , T I M E = G N S S ◀
2 . P O W E R O N R E C A L L
} ＊ O F F