Leader LT4670 - Lt4670-Ser01 (Gnss); Lt4670-Ser02 (Sdi)

3 SPECIFICATIONS
7
External Memory Support
The log can be saved and preset data can be written and saved from the panel using USB
memory devices.
Logging Function
The operation status can be logged to internal memory or external memory.
Last Memory Function
When the power is turned on, it starts up with the settings when the power was turned off last
time.
3.2.2 LT4670-SER01 (GNSS)
GNSS Sync
A GNSS antenna can be connected to generate and output signals by locking to the frequency
and clock obtained from the GPS, GLONASS, GALILEO, BDS, and QZSS.
It also features a stay in sync function, which retains the phase and frequency of the output
signal when GNSS signals are lost.
3.2.3 LT4670-SER02 (SDI)
Triple-rate SDI Ready
The SDI signal output supports 3G-SDI (level A and level B), HD-SDI, and SD-SDI. There are
two independent SDI signal output connectors, and different patterns and phases can be set for
each.
Also, two SER02 units can be mounted, and up to four independent SDI signals can be output.
Moreover, adding a 4K option (SER21) supports the 4K 3G-Quad Link.
User Pattern Generation (future support)
In addition to internal patterns such as the color bar, SD and HD (2K) user patterns can be
output.
ID Character Overlay
ID characters can be overlaid at any position on the display. In addition, ID characters can be
scrolled horizontally or displayed in a blinking state for checking whether the display has frozen.
Logo Mark Overlay (future support)
24-bit full-color bitmap data can be overlaid as a logo mark at any position on the display at a
640 (dots) × 480 (lines) VGA size.
Safety Area Markers
90% and 80% safety area markers can be overlaid on the display. For 3G-SDI and HD-SDI, a
4:3 aspect marker can be overlaid.