Leader LT4670 - Turning Lip Sync Interlock on and off (SER02); Setting the Silence Output; Settings Shared with the AES;EBU Output

9 AUDIO CONFIG MENU
78
9.1.9 Turning Lip Sync Interlock On and Off (SER02)
When SDI1 LIP SYNC on the SDI CONFIG menu is set to ON, to output a sound interlocked with
the lip sync pattern, select ON by following the procedure below.
[See also] "12.13 Turning Lip Sync On and Off"
Procedure
AUDIO CONFIG > AES/EBU > LIPSYNC(SYNC TO SDI1)
Parameters
ON / OFF
Initial value
OFF
9.2 Setting the Silence Output
Under SILENCE on the AUDIO CONFIG menu, you can specify settings for the silence output.
9.2.1 Settings Shared with the AES/EBU Output
To specify the settings for the silence output (resolution and timing) to be the same as those for
the AES/EBU output, select ON by following the procedure below. In this case, you cannot
specify the settings for the silence output.
Procedure
AUDIO CONFIG > SILENCE > EQUAL TO AES/EBU
Parameters
ON / OFF
Initial value
OFF
2 . L I P S Y N C ( S Y N C T O S D I 1 )
□ O N ■ O F F
0 . A U D I O C O N F I G
|}

S I L E N C E ↲
2 . E Q U A L T O A E S / E B U
□ O N ■ O F F