Leader LT4670 - Selecting the Genlock Format

7 REFERENCE CONFIG MENU
64
7.2 Selecting the Genlock Format
When REFERENCE SOURCE is set to GENLOCK FMT-MANUAL, to select the genlock format,
follow the procedure below. To select an item, use the ▲, ▼, ◀, and ▶ keys.
The genlock formats are expressed in terms of the total number of lines, not the number of
effective lines. REF represents the field reference pulse, and ID represents the field ID.
Procedure
REFERENCE CONFIG > GENLOCK FORMAT
Parameters
NTSC: NTSC BB / NTSC BB+REF / NTSC BB+ID / NTSC BB+REF+ID
PAL: PAL BB / PAL BB+REF
COMPONENT: 525/59.94I / 525/59.94P / 625/50I / 625/50P
1125:HD: 1125/60I / 1125/59.94I / 1125/50I / 1125/30P / 1125/29.97P /
1125/25P / 1125/24P / 1125/23.98P / 1125/24PsF /
1125/23.98PsF / 1125/60P / 1125/59.94P / 1125/50P
750:HD: 750/60P / 750/59.94P / 750/50P / 750/30P / 750/29.97P /
750/25P / 750/24P / 750/23.98P
Initial value
NTSC BB (when FORMAT SETTING on the SYSTEM CONFIG menu is set to NTSC)
PAL BB (when FORMAT SETTING on the SYSTEM CONFIG menu is set to PAL)
1 . G E N L O C K N T S C
u
} ＊ N T S C B B
1 . G E N L O C K P A L

} P A L B B
1 . G E N L O C K C O M P O N E N T

} 5 2 5 / 5 9 . 9 4 I
1 . G E N L O C K 1 1 2 5 : H D

} 1 1 2 5 / 6 0 I
1 . G E N L O C K 7 5 0 : H D

} 7 5 0 / 6 0 P