Leader LT4670 - Turning Jam Sync on and off; Setting the Jam Sync Time; Turning the Daylight Saving Time on and off (SER01)

14 SYSTEM CONFIG MENU
144
14.4.3 Turning Jam Sync On and Off
To turn the jam sync function on and off, follow the procedure below.
When set to ON, the time code is reset once a day at the time set on the ADJUST menu.
Procedure
SYSTEM CONFIG > TIME MANAGEMENT > JAM SYNC > ON/OFF
Parameters
ON / OFF
Initial value
ON
14.4.4 Setting the Jam Sync Time
To set when to reset the time code using the jam sync function, follow the procedure below.
This setting is valid when JAM SYNC is set to ON.
Procedure
SYSTEM CONFIG > TIME MANAGEMENT > JAM SYNC > ADJUST
Parameters
00:00:00 - 23:59:59
Initial value
00:00:00
14.4.5 Turning the Daylight Saving Time On and Off (SER01)
When TIME SOURCE on the REFERENCE CONFIG menu is set to GNSS, to select whether to
apply Daylight Saving Time, follow the procedure below.
Procedure
SYSTEM CONFIG > TIME MANAGEMENT > DAYLIGHT SAVING > ON/OFF
Parameters
ON / OFF
Initial value
OFF
3 . J A M S Y N C
■ O N □ O F F
3 . J A M S Y N C A D J U S T
0 0 : 0 0 : 0 0 [ H H : M M : S S ]
3 . D A Y L I G H T S A V I N G
□ O N ■ O F F