Leader LT4670 - Adjusting the Timing (Frame); Adjusting the Timing (Bit); Adjusting the Offset

10 LTC CONFIG MENU
82
10.3 Adjusting the Timing (Frame)
To adjust the timing of the LTC output relative to the reference signal at the frame level, follow
the procedure below.
Procedure
LTC CONFIG > LTC OUTPUT > LTC1 > TIMING > FRAME
Parameters
±29 [FRAME] (when the LTC format is set to 30 fps or 29.97 fps)
±24 [FRAME] (when the LTC format is set to 25 fps)
±23 [FRAME] (when the LTC format is set to 24 fps or 23.98 fps)
Initial value
0 [FRAME]
10.4 Adjusting the Timing (Bit)
To adjust the timing of the LTC output relative to the reference signal at the bit level, follow the
procedure below. At the lower right of the screen, the value in bits converted to time is
displayed.
Procedure
LTC CONFIG > LTC OUTPUT > LTC1 > TIMING > BIT
Parameters
±39 [BIT]
Initial value
0 [BIT]
10.5 Adjusting the Offset
To adjust the offset of the LTC output relative to the reference signal, follow the procedure
below.
Procedure
LTC CONFIG > LTC OUTPUT > LTC1 > OFFSET
Parameters
±23:59:59
Initial value
+00:00:00
4 . L T C 1 T I M I N G F R A M E
0 F R A M E
4 . L T C 1 T I M I N G B I T
0 B I T 0 . 0 0 0 m s
3 . L T C 1 O F F S E T
＋ 0 0 : 0 0 : 0 0 [ H H : M M : S S ]