Leader LT4670 - Setting Clicks; Settings Shared by Channels; Selecting the Resolution

9 AUDIO CONFIG MENU
76
9.1.3 Setting Clicks
To insert click sounds into the selected channel at the specified interval, follow the procedure
below.
This is invalid when LIPSYNC(SYNC TO SDI1) is set to ON and the SDI pattern is a lip sync one.
Procedure
AUDIO CONFIG > AES/EBU > SETTING > CH1 / CH2 > CLICK
Parameters
OFF / 1sec / 2sec / 4sec
Initial value
OFF
9.1.4 Settings Shared by Channels
To specify the settings for CH2 (frequency, level, and click sound) to be the same as those for
CH1, select ON by following the procedure below. In this case, you cannot specify the settings
for CH2.
Procedure
AUDIO CONFIG > AES/EBU > SETTING > CH2 > EQUAL TO CH1
Parameters
ON / OFF
Initial value
OFF
9.1.5 Selecting the Resolution
To select the resolution, follow the procedure below.
Procedure
AUDIO CONFIG > AES/EBU > SETTING > RESOLUTION
Parameters
20BIT / 24BIT
Initial value
20BIT
4 . A E S / E B U C H 1 C L I C K
} ＊ O F F
4 . C H 2 E Q U A L T O C H 1
□ O N ■ O F F
3 . A E S / E B U R E S O L U T I O N
■ 2 0 B I T □ 2 4 B I T