Leader LT4670 - Page 47

4 PANEL DESCRIPTION
34
6 3G SDI OUT 1, 2 (SER02)
7 3G SDI OUT 3, 4 (SER02)
Optional SDI output connector. It outputs SD, HD, and 3G signals.
Adding SER21 allows the connector to output the 4K 3G-Quad signal as well. (Two SER02
units are required.)
[See also] "6.3.4 SDI Signal Output (SER02)" "12 SDI CONFIG MENU (SER02)"
8 LTC/REMOTE
Time code and remote I/O connector.
A separately sold LTC cable (LC2185) is available for connection with LT4448.
[See also] "6.4 LTC Signal I/O and Remote Control" "10 LTC CONFIG MENU"
9 ETHERNET/CONTROL
Ethernet port.
It supports SNMP (future support), REST-API (future support), HTTP/HTTPS (HTTPS to be
supported in the future), and NTP.
10 ANALOG BLACK OUT 1-6
Analog black output connectors.
They output HD tri-level sync or NTSC/PAL black burst signals.
[See also] "6.3.1 Analog Black Signal Output" "8 BLACK CONFIG MENU"
11 GENLOCK/CW IN
Loop-through analog sync signal or 10 MHz CW input connectors.
For analog sync signals, input HD tri-level sync or NTSC/PAL black burst signals.
[See also] "6.2.2 Genlock Mode" "6.2.3 CW Mode" "7 REFERENCE CONFIG MENU"
12 WCLK
48 kHz word-clock output connector.
[See also] "6.3.2 Audio Signal Output" "9.3 Setting the Word-clock Output"
13 SILENCE
AES/EBU output connector compatible with DARS.
[See also] "6.3.2 Audio Signal Output" "9.2 Setting the Silence Output"
14 AES/EBU
AES/EBU output connector.
[See also] "6.3.2 Audio Signal Output" "9.1 Setting the AES/EBU Output"
15 Fan (LP2184)
Cooling fan for the instrument. It needs to be replaced periodically.
[See also] "17.2.3 Rear Fan Unit Replacement"