6 BASIC OPERATION
51
4. An error occurs in the reference signal
If an error occurs in the reference signal, the frequency that was in use immediately before
the error occurred is maintained (stay-in-sync function).
When stay-in-sync becomes active, GNSS and STAY light in orange, and the message
changes to "STAY". In this case, check the reference signal.
5. The reference signal is restored
When the reference signal is restored, STAY on the front panel blinks in orange, and the
message changes to "RECOVERY". Wait in this state.
6. Relock
When the instrument is relocked with the reference signal, GNSS on the front panel lights in
green and STAY turns off. In addition, the message changes to "LOCK". Use the instrument
in this state.
To Next Page
Loading...
