98
Fill the spray agent into the induction va-
lve.
Match the suction quantity, edge mois-
tening and intensity of the agitator nozz-
le to each other:
To prevent the induction gate overflo-
wing: Set the suction volume via the
suction valve.
Edge moistening must be set so that
the spray agent to be rinsed runs off
on a sliding film to the suction ope-
ning.
Adjust the intensity of the agitator
nozzle so that the spraying agent is
dissolved.
After rinsing the spray agent:
Clean the empty spray agent
canister.See "Cleaning empty canisters,
page 101".
Rinse the induction gate with clean wa-
ter. See "Flushing the induction system,
page 105".
If canisters are not cleaned or the pipe sys-
tem is flushed:
Close (1) cover.
Swivel the induction valve upwards into
the transport position.
Fold lever (2) downwards.
Snap lever (2) into place.
To Next Page
Loading...
