129
Switch the selection valve of the spray
pump (A) to change-over valve (C).
Place the switchover valve (C) on the
clean water tank.
In the control: Manual mode for control-
ling the distribution rate.
The work mask view changes.
To close the control valve: Press and
hold softkey for 10 seconds.
To open the control valve slightly: Press
and hold softkey for 3 seconds.
On the tractor: Switch on pump via PTO
shaft.
Operate pump at 400 rpm.
On the implement: Turn the flush valve
(1) so that the required spray pressure is
indicated in the control unit.
To Next Page
Loading...
