To prepare the implement in general:
Attach implement.
Check whether the implement is horizon-
tal in the direction of travel.
If the implement is NOT horizontal in the
direction of travel:
Have the drawbar adjusted by service
personnel or, if necessary, adjust the
height of the attachment point on the
tractor.
ATTENTION: Correct application of the
crop protection agent is only possible if
the implement is mounted horizontally
on the tractor in the direction of travel.
Mount and check cardan shaft.
Determine filling quantity of the imple-
ment.
Install the nozzles provided.
Calibrate the flow rate.
Calibrate the flowmeter.
Calibrate the speed sensor.
To Next Page
Loading...
