LEMKEN Primus-12 - Working on Rugged Terrain or on a Slope; Switching the Spray Fan or Spray Cone Lighting Equipment; Side Nozzles

Operation
147
7.13 Working on rugged terrain or on a slope
By changing the centre of gravity to com-
pensate for a slope, the position of the
boom can be adjusted to adapt to rugged
terrain or a slope so it is parallel to the
ground.
The position of the sprayer boom is adjust-
ed using the control system.
To learn how to change the position of the
sprayer boom, refer to the operating in-
structions for the SPRAYER controller
MIDI, Chapt. 6.2.4 and Chapt. 6.2.5.
To learn how to adjust the sprayer boom to
a slope when turning, refer to Chapt. 6.2.6.
7.14 Switching the spray fan or spray cone lighting equipment
The spray fan or spray cone lighting
equipment can be switched via the control.
See operating manual SPRAYER control-
ler MIDI, Chapter 6.10 Operating additional
functions - activate/deactivate working
lights.
7.15 Side nozzles
Edge nozzles are nozzles with a different
spray pattern than the other nozzles on the
sprayer boom.
NOTE: When using edge nozzles, the ap-
plicable national regulations and laws must
be observed.