LEMKEN Primus-12 - Apply Spraying Agent

Operation
145
7.12.2 Apply spraying agent
 Bring the tractor-implement combination
into position.
 Spraying:
 Move over the processing area with
the tractor-device combination.
 Switch on the nozzles.
 During application, drive at a speed
that matches the installed nozzles and
the application rate set.
 To avoid the spraying agent drifting: First
spray the outer perimeter of the property
with drift-free nozzles.
 Use drift-free nozzles or, e.g., end
nozzles.
or
 Switch off any outer nozzles.
 Then spray the inside of the spray lanes
with application-specific nozzles.
 Monitor and, if necessary, adjust distri-
bution rate, pressure and forward speed.
 Depending on the implement equipment,
monitor the level at the following loca-
tions:
 Indirect level indicator on the main
tank
 Filling level indicator TANK control at
the operating centre
 Control of the device at the operating
terminal