LEMKEN Primus-12 - Rims; Drive Shaft

Technical data
234
11.9 Rims
The rims of the implement have a load
capacity that corresponds to at least half
the permissible axle load.
The rims are fit for both-sided use.
The offset (ET) [mm] of the rim is +56 or
+106.
10
Number of drill holes for wheel nuts (piece)
280
Ø of the hub [mm]
335
Ø of the bolt circle for wheel bolts [mm]
11.10 Drive shaft
Version
Connection
To tractor
To implement
Standard 1
1 ⅜ (6)
1 ⅜ (6)
Standard 2
1 ⅜ (8)
1 ⅜ (6)
Standard 3
1 ⅜ (21)
1 ⅜ (6)
Wide angel, single side
1 ⅜ (6)
1 ⅜ (6)
1 ⅜ (21)
1 ⅜ (6)
Wide angel, both sides
1 ⅜ (6)
1 ⅜ (6)
1 ⅜ (8)
1 ⅜ (6)
 Required clearance for tractor-side wide angle joint to trailer coupling etc.: 120
mm