233
driving and braking characteristics of the implement due to conversion of the
wheels must be examined by an expert. In case of critical driving conditions, the
technical data of the implement must be modified and the filling quantity (kg)
and/or the maximum permissible speed must be reduced.
If a certificate is provided for the implement, only the wheels listed in the certifi-
cate may be used.
If wheels other than those provided in the certificate are to be used, the certifi-
cate must be amended by the relevant authority.
We recommend that an enquiry is made to the relevant authority before chan-
ging the wheels.
If existing wheels are to be used, these wheels must also comply with the listed
criteria.
In order to utilise the maximum load bearing capacity of the axles, the tyres and
rims of each pair of wheels must have at least the load bearing capacity of the
axle.
Furthermore, the wheels must be in a good condition.
The individual driving speeds for the individual wheels at the particular maxi-
mum permissible load must also be taken into account.
If pairs of wheels are used with a lower load bearing capacity than the maxi-
mum permissible axle load, the filling quantity of the tanks must be adjusted so
that the maximum load bearing capacity of the wheels is not exceeded.
The permissible filling quantity in litres is reduced for spraying liquids with a
greater weight than water.
It must also be taken into account that the maximum permissible load bearing
capacities of the wheels and the maximum axle loads must also be observed for
these liquids.
To Next Page
Loading...
