102
Hold the cut-off piece of the inner protec-
tion tube (2) over the inner profile tube
(9) and cut off the inner profile tube (9)
at a right angle.
Deburr and clean the outer and inner
profile tubes.
Grease the inner profile tube with multi-
purpose grease.
Ensure that the PTO shaft guard of the
PTO shaft is secured with the chain (1)
at a fixed point against rotating.
6.5 Determining filling quantities of the implement
The implement may only be filled up to the permissible loads.
Observe the technical data according to these operating instruc-
tions and the national approval documents.
To Next Page
Loading...
