LEMKEN Primus-12 - Switch Edge Nozzles; Install Edge Nozzles

Operation
148
The following edge nozzles are available:
 Edge nozzles with one-sided spray cone
for sharp-edged treatment
 Extension nozzles - variable and ad-
justable jet nozzles
7.15.1 Switch edge nozzles
The edge nozzles are switched via the
control unit: See Chapter 7.9.2 of operating
instructions for SPRAYER controller
MIDI 3.0.
Edge nozzles are not taken into account in
the calculations of the control system. As a
result, the following values in the displays
of the control may deviate from the actual
values during distribution:
 Working width
 Applied quantity
 Contents of container
To optimise the calculations, the control
adjustments can be set: See Chapter 7.9.1
of operating instructions for SPRAYER
controller MIDI 3.0.
7.15.2 Install edge nozzles
Prerequisite: The edge nozzles meet the
following requirements:
 Same size and comparable nozzle cha-
racteristics to the built-in nozzles
 They comply with national regulations