LEMKEN Primus-12 - Page 8

6
5.23 Pendulum suspension and slope compensation ..................................................... 78
5.24 Stabiliser ...................................................................................................................... 79
5.25 DISTANCE-Control ...................................................................................................... 79
5.26 Hydraulic flow dividers and pressure limiting valves .............................................. 80
5.27 Boom ............................................................................................................................ 81
5.27.1 Part-width section valves ........................................................................................ 81
5.27.2 Single nozzle valves ............................................................................................... 82
5.27.3 Nozzle holders ........................................................................................................ 82
5.27.4 Nozzles .................................................................................................................. 83
5.27.5 Spacer .................................................................................................................... 83
5.27.6 Spray cone lighting ................................................................................................. 83
5.28 Drop hose .................................................................................................................... 84
6 Preparations ............................................................................................................ 85
6.1 Preparations on tractor ............................................................................................... 85
6.1.1 Checking the suitability of the tractor for the implement ............................................ 85
6.1.2 Check tractor tire pressure ........................................................................................ 89
6.1.3 Installation of the operation terminal .......................................................................... 89
6.2 Brake system ............................................................................................................... 89
6.2.1 Air brake system ........................................................................................................ 90
6.2.2 Hydraulic brake system ............................................................................................. 90
6.2.3 Without braking system ............................................................................................. 90
6.3 Preparations on the implement .................................................................................. 91
6.3.1 Standard procedure ................................................................................................... 91
6.3.2 Implement with compressed air brake ....................................................................... 92
6.4 Attaching the implement ............................................................................................ 95
6.4.1 Attaching the implement with drawbar eye ................................................................ 95
6.4.2 Attaching the implement with cross shaft ................................................................... 97
6.4.3 Conversion of device ................................................................................................. 99
6.4.4 Devices with air brake systems ................................................................................. 99
6.4.5 Implement with hydraulic braking system ................................................................ 100
6.4.6 Checking and attaching the cardan shaft................................................................. 100
6.5 Determining filling quantities of the implement ..................................................... 102