Diagnostic information 2-9
5060-4xx
107 Printhead Error Magenta printhead lost Hsync
Check for the correct installation of all the cables to the system board
assembly and to the printhead assembly; J11 and J12 on the system
board. Go to “System board” on page 5-8. If the cables are connected
correctly to the system board and to the printhead assembly, go to
“Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
108 Printhead Error Yellow printhead lost Hsync
Check for the correct installation of all the cables to the system board
assembly and to the printhead assembly; J7 and J8 on the system board.
Go to “System board” on page 5-8. If the cables are connected
correctly to the system board and to the printhead assembly, go to
“Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
109 Printhead Error Black printhead lost Hsync
Check for the correct installation of all the cables to the system board
assembly and to the printhead assembly; J12 and J13 on the system
board. Go to “System board” on page 5-8. If the cables are connected
correctly to the system board and to the printhead assembly, go to
“Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
110 Printhead Error No first Hysnc - cyan
Check for the correct installation of all the cables to the system board
assembly and to the printhead assembly; J8 and J9 on the system board.
Go to “System board” on page 5-8. If the cables are connected
correctly to the system board and to the printhead assembly, go to
“Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
111 Printhead Error No first Hysnc - magenta
Check for the correct installation of all the cables to the system board
assembly and to the printhead assembly; J11 and J12 on the system
board. Go to “System board” on page 5-8. If the cables are connected
correctly to the system board and to the printhead assembly, go to
“Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
112 Printhead Error No first Hysnc - yellow
Check for the correct installation of all the cables to the system board
assembly and to the printhead assembly; J7 and J8 on the system board.
Go to “System board” on page 5-8. If the cables are connected
correctly to the system board and to the printhead assembly, go to
“Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
Error code Action
To Next Page
Loading...
