2-10 Service Manual
5060-4xx
113 Printhead Error No first Hysnc - black
Check for the correct installation of all the cables to the system board and
in the printhead assembly; J12 and J13 on the system board. Go to
“System board” on page 5-8. If the cables are connected correctly, go
to “Printhead diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
114 Printhead Error A black printhead servo error has been detected.
Verify all packing material have been removed from the printer and the
printhead.
If error persists, see “Printhead diagnostics” on page 3-1.
115 Printhead Error A cyan printhead servo error has been detected.
Verify all packing material have been removed from the printer and the
printhead.
If error persists, see “Printhead diagnostics” on page 3-1.
116 Printhead Error A magenta printhead servo error has been detected.
Verify all packing material have been removed from the printer and the
printhead.
If error persists, see “Printhead diagnostics” on page 3-1.
Error code Action
To Next Page
Loading...
