2-28 Service Manual
5060-4xx
Close Door This message is displayed when the printer upper front
cover (door) is open.
Close the upper front cover (door).
Close <tray> Door This message is displayed when the HCIT (2000-sheet)
option tray door is open. Close the tray door to clear the
message.
Close Finisher Door This message is displayed when the Finisher Option front
door is open. Close the finisher front door.
Disk Corrupted This message is displayed when the printer has detected
that there are errors on the hard disk that could not be
corrected. The disk cannot be used until it has been
reformatted.
The following actions can be taken:
• Press Return or Stop to clear the message.
The disk cannot be used without reformatting the disk.
Warning: All data will be lost if you press Go to format the
disk.
Empty Hole Punch
Box
This message is displayed when the Hole Punch Alarm is
On and the code has determined that the Hole Punch Waste
Box is completely full.
The following actions may be taken while this message is
displayed:
• The user may empty the Hole Punch Box and put it back
to clear the message.
• Press Go to ignore the message and the job prints
without hole punching.
Each time a new job requests Hole Punch and the box is not
emptied, this message is displayed.
Priming Failed, Retry.
GO/Stop
This message is displayed when an error has occurred
during the printer staple priming operation.
The following actions can be taken:
• Press Go to initiate the priming operation again or
• Press Return or Stop to cancel the priming operation.
Note: If no action is taken and the printer Auto Continue
setting is not disabled, the printer eventually clears the
message, the priming operation is canceled, and the printer
resumes printing.
Insert Staple
Cartridge
This message is displayed when the staple cartridge is
missing or installed incorrectly. This message can be
displayed at any of the following times, regardless of the
Staple Alarm setting.
• At POST
• After the Stapler Door has been closed.
The following actions can be taken:
• Install the staple cartridge
or
• Press Go to ignore this message.
The printer now handles staple jobs as if the staple unit
were installed with no staples. The Staples Empty warning
appears on the status line and Load Staples may
immediately appears.
User primary
message
User secondary
message
Explanation
To Next Page
Loading...
