Diagnostic information 2-29
5060-4xx
Load Staples This message is displayed when the Staples Empty Alarm is
activated and there are no staples in the staple unit or the
staple unit is not installed.
This message appears:
• Prior to printing the first page of a batch of pages that
are to be stapled
or
• During the printing of a batch of pages that are to be
stapled (if the condition cannot be detected prior to
printing the first page of the batch).
The following actions can be taken:
• A new staple cartridge may be installed to clear this
message and start/continue printing the staple batch
or
• Ignore the Load Staples request for this print job by
pressing Go or Select. The printer resumes printing,
however the print job for which stapling was selected is
not stapled
or
• Press Menu to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting
Menu:
•Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
User primary
message
User secondary
message
Explanation
To Next Page
Loading...
