EasyManua.ls Logo

Lexmark C760 - Page 76

Lexmark C760
466 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-40 Service Manual
5060-4xx
85 ITU
Maintenance
Check printouts for excess toner. If present, replace the
suspect cartridge. Otherwise, replace the “ITU assembly”
on page 4-44. Press Go to continue, however, the message
persists until replacement.
86 ITU
Maintenance
This message displays when the ITU reaches end of life.
Check printouts for excess toner. If present, replace the
suspect cartridge. Otherwise, Replace the “ITU assembly”
on page 4-44. Press Go to continue, however, the message
persists until replacement.
87 Fuser Missing This message is displayed when the engine detects the
fuser is missing.
Turn the printer off and insert the fuser assembly.
88 Yellow Toner
Low
88 Magenta Toner
Low
88 Cyan Toner
Low
88 Black Toner
Low
These messages are displayed when either the Yellow,
Magenta, Cyan, or Black toner cartridge is low on toner.
The following actions can be taken:
Open the front door, remove the old toner cartridge,
insert a new toner cartridge, and close the door
or
Press Go without changing the toner cartridge and
continue.
89 ITU
Maintenance
Check the ITU Release Lever for correct operation. The ITU
Release Lever is the black lever located on the left upper
side frame above the ITU opening and can be seen by
opening and lowering the MPF Assembly. When locked the
lever should be at the 6 o'clock position. When unlocked it
should be in a 3 o'clock position. Undue pressure is not
required to operate the lever
Turn the printer off, insert the ITU, move the lever to the 6
o'clock position, and turn the printer back on.
If this does not resolve, replace the ITU assembly” on
page 4-44.
Press Go to continue. The message persists until
replacement.
1565 Emul Error Load
Emul Option
This message appears when the IPDS emulation version
contained in the SIMM does not function with the printer
code. This message automatically clears in 30 seconds, and
the IPDS emulation is disabled. No other printer functions
are affected. The correct IPDS emulation must be
downloaded.
User primary
message
User secondary
message
Explanation

Table of Contents

Other manuals for Lexmark C760

Related product manuals