Lexmark C760 - Page 75

Diagnostic information 2-39
5060-4xx
63 Unformatted Disk This message is displayed when the printer detects an
unformatted disk at POST.
Press Go to clear the message.
The disk is marked as bad and normal operation continues,
however disk operation is not allowed until the disk is
formatted.
64 Unsupported Disk
Format
This message is displayed when the printer detects an
unsupported disk format at POST. This message may
appear if the disk was formatted on another system with a
different format.
Press Go to clear the message.
The disk is marked as bad and normal operation continues,
however disk operations is not allowed until the disk is
formatted.
80 Fuser
Maintenance
This messages displays when the printer requires
replacement of a worn assembly. The message is
independently posted when a fuser needs to be replaced.
Press Go to clear this message. See “Scheduled
maintenance” on page 6-4 for the part number of the
maintenance kit.
81 Engine Code CRC
Failure
This message is displayed when microcode programmed
into the engine flash code fails a CRC check.
Press Go to clear the message.
The code data is discarded and must be resent from the
host computer.
82 Waste Toner
Bottle Full
This message is displayed when the waste container is full.
Replace the waste container and press Go.
82 Waste Toner
Bottle Missing
This message is displayed when the waste container is
missing.
Insert the waste container and press Go.
82 Waste Bottle
Nearly Full
This message is displayed when the waste container is
nearly full.
Press Go
Nearly Full appears in the Supplies Menu.
83 ITU
Maintenance
This message displays when the ITU reaches end of life. It is
recommended the customer order the maintenance kit. See
“Scheduled maintenance” on page 6-4 for the part
number of the maintenance kit. You can press Go to
continue, however, the message persists until replacement.
84 Replace
Oiler
This message is displayed when the web oiler is exhausted
or missing. Replace the web oiler. See “Scheduled
maintenance” on page 6-4 for the part number of the web
oiler fuser replacement kit.
84 Oiler Nearly
Exhausted
This message is displayed when the web oiler is nearly
exhausted. Press Go to continue to clear this message.
If 84 Oiler Nearly Exhausted message does not clear after a
new web oiler has been installed, replace parts in the
following order:
• Fuser web oiler drive motor assembly
• Fuser web oiler card.
User primary
message
User secondary
message
Explanation