Lexmark MS711 - Page 132

Error code Description Action
424.03 The media fed did not reach the output option 1/high
capacity output expander sensor (pass through).
Go to “HCOE media entrance jam service check” on
page 153.
424.05 The media while feeding remains detected by the
output option 1/high capacity output expander
sensor (pass through).
Go to “Sensor (HCOE pass through) jam service
check” on page 150.
424.09 Never received Page In Output from output option
1/high capacity output expander
Go to “HCOE media entrance jam service check” on
page 153.
424.10 Invalid Page ID returned by output option 1/high
capacity output expander
Go to “HCOE media entrance jam service check” on
page 153.
424.41 Output option 1/high capacity output expander
main/interface motor stalled
Go to “HCOE main motor jam service check” on
page 156.
424.42 Output option 1/high capacity output expander
main/interface motor did not reach the required
speed.
Go to “HCOE main motor jam service check” on
page 156.
424.43 Took too long to ramp up main/interface motor in
output option 1/high capacity output expander
Go to “HCOE main motor jam service check” on
page 156.
424.53 Output option 1/high capacity output expander
main/interface motor did not reach the required
speed.
Go to “HCOE main motor jam service check” on
page 156.
424.71 Diverter failed to leave its home position on the
output option 1/high capacity output expander
Go to “HCOE diverter jam service check” on
page 148.
424.72 Diverter failed to reach its home position on the
output option 1/high capacity output expander
Go to “HCOE diverter jam service check” on
page 148.
427.01 Media remains detected by the output option 2/high
capacity output expander sensor (pass through) after
power on.
Go to “Sensor (HCOE pass through) jam service
check” on page 150.
427.03 The media fed did not reach the output option 2/high
capacity output expander sensor (pass through).
Go to “HCOE media entrance jam service check” on
page 153.
427.05 The media while feeding remains detected by the
output option 2/high capacity output expander
sensor (pass through).
Go to “Sensor (HCOE pass through) jam service
check” on page 150.
427.09 Never received Page In Output from output option
2/high capacity output expander
Go to “HCOE media entrance jam service check” on
page 153.
427.10 Invalid Page ID returned by output option 2/high
capacity output expander
Go to “HCOE media entrance jam service check” on
page 153.
427.41 Output option 2/high capacity output expander
main/interface motor stalled
Go to “HCOE main motor jam service check” on
page 156.
427.42 Output option 2/high capacity output expander
main/interface motor did not reach the required
speed.
Go to “HCOE main motor jam service check” on
page 156.
427.43 Took too long to ramp up main/interface motor in
output option 2/high capacity output expander
Go to “HCOE main motor jam service check” on
page 156.
4063
Diagnostic information
132