Error code Description Action
451.05 Staple, hole punch finisher: The media while feeding
remains detected by the sensor (pass through).
Go to “Sensor (HPU finisher pass through) jam
service check” on page 180.
451.09 Never received Page In Output from the
finisher/offset stacker
451.10 Invalid Page ID returned by the finisher/offset stacker
451.41 Finisher/offset stacker: Main/interface motor stalled Go to “Finisher main motor jam service check” on
page 166.
451.41 Staple, hole punch finisher: Main/interface motor
stalled
Go to “Finisher (HPU) main motor jam service
check” on page 178.
451.42 Finisher/offset stacker: Main/interface motor did not
reach the required speed.
Go to “Finisher main motor jam service check” on
page 166.
451.42 Staple, hole punch finisher: Main/interface motor did
not reach the required speed.
Go to “Finisher (HPU) main motor jam service
check” on page 178.
451.43 Finisher/offset stacker: Took too long to ramp up
main/interface motor
Go to “Finisher main motor jam service check” on
page 166.
451.43 Staple, hole punch finisher: Took too long to ramp up
main/interface motor
Go to “Finisher (HPU) main motor jam service
check” on page 178.
452.73 Finisher/offset stacker: left tamper failed to leave its
home position
Go to “Finisher left tamper jam service check” on
page 161.
452.73 Staple, hole punch finisher: left tamper failed to leave
its home position
Go to “Finisher (HPU) left tamper jam service
check” on page 183.
452.74 Finisher/offset stacker: left tamper failed to reach its
home position
Go to “Finisher left tamper jam service check” on
page 161.
452.74 Staple, hole punch finisher: left tamper failed to reach
its home position
Go to “Finisher (HPU) left tamper jam service
check” on page 183.
453.75 Finisher/offset stacker: right tamper failed to leave its
home position
Go to “Finisher right tamper jam service check” on
page 163.
453.75 Staple, hole punch finisher: right tamper failed to
leave its home position
Go to “Finisher (HPU) right tamper jam service
check” on page 184.
453.76 Finisher/offset stacker: right tamper failed to reach
its home position
Go to “Finisher right tamper jam service check” on
page 163.
453.76 Staple, hole punch finisher: right tamper failed to
reach its home position
Go to “Finisher (HPU) right tamper jam service
check” on page 184.
454.41 Finisher/offset stacker: ejector motor stalled Go to “Finisher ejector jam service check” on
page 165.
454.41 Staple, hole punch finisher: ejector motor stalled Go to “Finisher (HPU) ejector jam service check” on
page 179.
454.42 Finisher/offset stacker: ejector motor did not reach
the required speed.
Go to “Finisher ejector jam service check” on
page 165.
454.42 Staple, hole punch finisher: ejector motor did not
reach the required speed.
Go to “Finisher (HPU) ejector jam service check” on
page 179.
4063
Diagnostic information
135
To Next Page
Loading...
