Lexmark MS711 - Page 134

Error code Description Action
436.42 Output option 2/mailbox main/interface motor did
not reach the required speed.
Go to “Mailbox main motor jam service check” on
page 142.
436.43 Took too long to ramp up main/interface motor in
output option 2/mailbox
Go to “Mailbox main motor jam service check” on
page 142.
436.53 Output option 2/mailbox main/interface motor did
not reach the required speed.
Go to “Mailbox main motor jam service check” on
page 142.
436.71 Diverter failed to leave its home position on the
output option 2/mailbox
Go to “Mailbox diverter plunger jam service check”
on page 144.
436.72 Diverter failed to reach its home position on the
output option 2/mailbox
Go to “Mailbox diverter plunger jam service check”
on page 144.
441.01 Media remains detected by the output option
3/mailbox sensor (pass through) after power on.
Go to “Sensor (mailbox pass through) jam service
check” on page 139.
441.03 The media fed did not reach the output option
3/mailbox sensor (pass through).
Go to “Sensor (mailbox pass through) jam service
check” on page 139.
441.05 The media while feeding remains detected by the
output option 3/mailbox sensor (pass through).
Go to “Sensor (mailbox pass through) jam service
check” on page 139.
441.09 Never received Page In Output from output option
3/mailbox
Go to “Sensor (mailbox pass through) jam service
check” on page 139.
441.10 Invalid Page ID returned by output option 3/mailbox Go to “Sensor (mailbox pass through) jam service
check” on page 139.
441.41 Output option 3/mailbox main/interface motor
stalled
Go to “Mailbox main motor jam service check” on
page 142.
441.42 Output option 3/mailbox main/interface motor did
not reach the required speed.
Go to “Mailbox main motor jam service check” on
page 142.
441.43 Took too long to ramp up main/interface motor in
output option 3/mailbox
Go to “Mailbox main motor jam service check” on
page 142.
441.53 Output option 3/mailbox main/interface motor did
not reach the required speed.
Go to “Mailbox main motor jam service check” on
page 142.
441.71 Diverter failed to leave its home position on the
output option 3/mailbox
Go to “Mailbox diverter plunger jam service check”
on page 144.
441.72 Diverter failed to reach its home position on the
output option 3/mailbox
Go to “Mailbox diverter plunger jam service check”
on page 144.
451.01 Finisher/offset stacker: Media remains detected by
the sensor (pass through) after power on.
Go to “Sensor (finisher pass through) jam service
check” on page 158.
451.01 Staple, hole punch finisher: Media remains detected
by the sensor (pass through) after power on.
Go to “Sensor (HPU finisher pass through) jam
service check” on page 180.
451.03 Finisher/offset stacker: The media fed did not reach
the sensor (pass through).
Go to “Sensor (finisher pass through) jam service
check” on page 158.
451.03 Staple, hole punch finisher: The media fed did not
reach the sensor (pass through).
Go to “Sensor (HPU finisher pass through) jam
service check” on page 180.
451.05 Finisher/offset stacker: The media while feeding
remains detected by the sensor (pass through).
Go to “Sensor (finisher pass through) jam service
check” on page 158.
4063
Diagnostic information
134